Operation; Transmission Range - Conrad RSLR2 Bedienungsanleitung

Operation

Connect the consumer load to the front socket (2).
Please consult the section "Technical Data" for the consumer load's permis-
sible maximum power.
By pressing the respective ON or OFF button for the switching channel on the radio transmitter,
you can turn the remote controlled socket switch on (the LED (1) lights up) or off (the LED (1)
goes out).
The remote controlled socket switch can be switched on or off manually using the "ON/OFF"
button (1) located on the front.
Maintenance and Care
The product does not require any maintenance and should never be opened or disassembled
for any reason.
Remove connected consumer loads from the remote controlled socket switch and remove it
from the mains socket, before cleaning the product.
Only clean the product with a soft, clean, dry cloth. Never use aggressive cleaning agents or
chemical solutions since these might damage the surface of the casing or impair the operation.
Handling
• The remote controlled socket switch is only intended for use in dry indoor spaces.
• The following unfavourable conditions should be avoided at the installation site
and during transport:
- Humidity and damp
- Direct sunlight
- Extreme cold or heat
- Dust or fl ammable gases, fumes or solvents
- Strong vibrations
- Strong magnetic fi elds such as those found in the vicinity of machinery or loud-
speakers
• Ensure that the insulation for the entire product is neither damaged nor destroyed.
Never disassemble the product! There are no serviceable parts inside.
• Check the product for damage before each use!
If you notice any damage, do not use the product any longer!
There is a risk of a life-threatening electric shock!
Safe operation must be presumed to be no longer possible:
- if the device is visibly damaged
- if the device no longer works
- if the device was stored under unfavourable conditions for a long period of time
- if it was exposed to extraordinary stress caused by transport

Transmission range

The transmission range of the radio signals, between the radio transmitter and the remote
controlled socket switch, is up to 70 m under optimum conditions.
☞
This value, however, is the so-called "open space range" (the range the trans-
mitter and receiver are visible to each other, without disturbing infl uences).
In practical operation, however, there are walls, ceilings of rooms etc. between
the transmitter and the receiver, which reduce the range accordingly.
Due to the different infl uences on the radio transmission, no specifi c range
can be guaranteed.
Nevertheless, trouble-free operation in a single-family home is usually pos-
sible.
The range can sometimes be limited considerably by:
• Walls, reinforced concrete ceilings
• Coated/metallised insulated glass
• Proximity to metal & conducting objects (e.g., radiators)
• Proximity to human bodies
• Broadband interferences, e.g. in residential areas (DECT telephones, mobile phones, radio-
controlled headphones, radio-controlled speakers, radio-controlled weather stations, baby
phones etc.)
• Proximity to electric motors, transformers, power-supply units, computers
• Proximity to improperly shielded or uncovered operating computers or other electrical
devices
Disposal
Dispose of an unserviceable product in accordance with the relevant statutory regu-
lations.
Declaration of Conformity (DOC)
We, Conrad Electronic, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that this
product conforms to the fundamental requirements and the other relevant regulations of the
directive 1999/5/EC.
☞
The Declaration of Conformity for this product can be found at www.conrad.com.
Technical Data
Reception frequency: ..................433 MHz
Operating voltage: ......................230 V/AC, 50 Hz
Protection class: .........................I
Connected power: ...................... max. 2000 watts ohm resistive load; max. 600 watts inductive
load
LED: ............................................Lights up, when the mains socket/consumer load is activated
Dimensions (L x W x H): .............approx. 116 x 58 x 73 mm
Operating temperature range: ....0 °C to +35 °C
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfi lming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2012 by Conrad Electronic SE.