Conrad 61 05 83 Bedienungsanleitung Seite 20

• Remove the four screws of the cover plate for the screw contacts on the outdoor unit.
• Connect the two open cable ends with the two "LINE+" and "LINE-" screw clamps. The back cable must be
connected with the "LINE-" screw clamp, the coloured cable with the "LINE+" screw clamp.
• If you want to control a door opener, the "UNLOCK" connection is available here. It provides the power for a
traditional 12V door opener. No further power supply is necessary.
• Refit the cover plate and screw it tight. Ensure that its rubber seal is inserted properly. The connection cable can
be led through a rubber seal inside the cover plate.
• Connect the connection cable's round plug with the "LINE" socket.
Warning! Never use the "AV OUT" socket. This can damage both the indoor and outdoor unit, loss of
guarantee/warranty.
The indoor and outdoor unit must only be connected to one another via the "LINE" socket.
The "AV OUT" socket only provides the AV signal in order to be able to connect another monitor, for
instance. It is not intended for connecting the outdoor unit.
• Connect the low-voltage adaptor of the mains adaptor with the respective socket on the rear of the indoor unit.
• Put the plug-in power supply into a mains socket. The green standby LED on the front of the indoor unit lights.
20
AV Out
LINE