GBC FUSION 5000L Bedienungsanleitung Seite 6

GB
getting ready to laminate
Easy Set Up
1 Remove the plastic exit tray from the box and place into the two holes on the back of the
laminator and extend to use. Ensure that there is sufficient space behind the laminator for the
item to be removed.
2 Take the electrical plug and place in an appropriate power source, which is near the table you
intend to use.
3 The laminator will briefly flash the GBC logo on the control panel and will make an audible beep.
Interactive User Display
4 To use the laminator gently tap the 'power on' button. A sequence of lights will cross the control
panel.
NOTE: Your new laminator may emit
a slight odour during the initial
operation. Its is normal and will
diminish after a few hours of
operation.
5 If 75mic is not the pouch thickness you want to select, using the arrows scroll until the required
pouch thickness setting is shown and press "Enter".
Intelligent Pouch Select
Using the 'Auto' setting allows the user to use any thickness of pouch and the laminator
6
will automatically measure the thickness of the pouch and document and self set to the
appropriate speed.
NOTE: During warm up a circle will be
formed on the control panel and a
red indicator will flash in the centre
of the circle until ready (
When ready a series of three beeps
are heard and the (
on the display. The machine will not
take any pouch during warm up.
6
register this product online at www.accobrands.com
).
) will show