Charging The Run Trainer ™ 2.0 Gps - Timex IRONMAN Run TRAINER Schnellstartanleitung

CHARGING THE RUN TRAINER
Before you use the watch for the first time, charge the battery for at least
4 hours to insure complete charging. This is confirmed by a flashing
battery icon.
In order to maximize the rechargeable battery life:
• Deplete the battery until the last battery indicator segment disappears
and the empty indicator begins to flash. If the watch display goes
blank, you can still proceed as long as it has been in that state for no
more than 1-2 days.
• Fully charge the watch battery for at least 4 hours until all four
segments in the battery level indicator are no longer blinking.
• Repeat this discharge/recharge procedure two more times.
NOTE: You should repeat this procedure every two months if the watch
is not used or recharged regularly.
Charge within a temperature range of 32°F - 113°F (0°C - 45°C).
10
2.0 GPS
™
The charging cable has a clip on one end and a standard USB connector on
the other end.
1. Attach the clip to the watch so the four pins on the clip align with the
four metal contacts on the back of the watch. The clip has two black
pins that align the clip into the watch case back.
2. Insert the other end of the cable into a powered USB port on your
computer. The blinking battery level icon confirms that the watch is
charging.
The battery icon flashes during charging. The four segments in the icon
indicate the charge of the battery; more solid segments means a
higher charge.
11