H.
A. A A
D.
B.
KEY
C.
A. SafeSense
B. Paper/card entry
C. See safety instructions
E/F.
D. CD entry
E. Pullout bin
F. Basket - CD (inside)
G.
G. Casters
H. Disconnect power switch
CAPABILITIES
Will shred: Paper, credit cards, CD/DVD's, and standard staples
Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper,
cardboard, *paper clips, non-standard staples, 3 1/2" diskettes, laminates, file folders, X-rays
or plastic other than noted above
Paper/Card shred size:
Micro-Cut .....................................................................................................2mm x 10mm
CD shred size:
Strip-Cut .................................................................................................................. 10mm
*Paper clip shredding is not recommended for this shredder
Machine Noise Information- Regulation-3.GSGV
The emitted sound pressure level (LpA) for the orientation of the
operator according to EN ISO 7779:2001
Model
Idling
Operating
MS-460Ci
60 dB(A)
65 dB(A)
ADVANCED PRODUCT FEATURES
Jam Proof System
Patented SafeSense
Eliminates frustrating jams
Technology
by preventing overloads
Stops shredder immediately
and powering through
when hands are too close to
misfed paper.
the paper entry.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keep away from children and pets. Keep hands away from paper
entry. Always set to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away
from shredder openings. If object enters top opening, switch to
Reverse (
) to back out object.
• Never use aerosol products, petroleum based lubricants or other flammable
products on or near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not disassemble shredder. Do
not place near or over heat source or water.
BASIC SHREDDING OPERATION
PAPER/CARD OR CD
1
2
Continuous operation:
15-minute maximum
Plug in and put
Press ( ) ON to
NOTE: Shredder runs briefly after
disconnect power
activate (blue)
each pass to clear entry. Continuous
switch in ON (I) position
operation beyond 15-minutes will
www.fellowes.com features an extensive on-line support section with a number of self-service options
trigger 25-minute cool down period.
2
MS-460Ci_403736_18L_RevC_111108.indd Sec1:2-Sec1:3
MS-460Ci_403736_18L_RevC_111108.indd Sec1:2-Sec1:3
Technology
Control Panel and LEDs
7. Auto correcting button (blue)
®
1. Overheat (red)
8. Reverse
2. Bin open (red)
9. ON/OFF (blue)
3. Bin full (red)
10.Forward
4. Remove paper (red)
5. SafeSense
indicator (yellow)
®
6. Sheet capacity indicator
Maximum:
Sheets per pass (70g paper) ........................................................................................ 12*
Sheets per pass (80g paper) ........................................................................................ 10*
CDs/Cards per pass ......................................................................................................... 1
Paper/card entry width ......................................................................................... 230mm
CD entry width ..................................................................................................... 132mm
* A4 paper at 220-240v, 50Hz, 3.5Amps; heavier paper, humidity or other than rated voltage
may reduce capacity. Recommended daily usage rates: 50-100 shredding passes per day,
50 credit cards; 10 CDs.
Fellowes SafeSense
®
shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
®
SilentShred™ Technology
MicroShred Technology
SilentShred™ noise quality
MicroShred cut provides
maximum security by shredding
shreds without noisy
disruptions.
paper into over 3100 particles
per 210mm x 297mm sheet.
• This shredder has a Disconnect Power Switch (H) that must be in the ON (I) position to
operate shredder. In case of emergency, move switch to OFF (O) position. This action will
stop shredder immediately.
• Avoid touching exposed cutting blades under shredder head.
• Use only designated entry for shredding CDs
• Keep fingers away from CD hole when shredding.
• Do not put foreign objects in paper entry.
• The grounded socket-outlet shall be installed near the equipment and shall be
easily accessible.
3
5
6
Feed paper/Card
Hold CD at edge,
When finished
straight into paper
feed into CD
shredding set
entry and release
entry and release
to OFF ( )
ENGLI H H H H SH SH SH ISH ISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
NGLISH
NGLISH
NGLISH
NGLISH
GLISH
GLISH
GLISH
GLISH
LISH
LISH
LISH
Model MS-460Ci
el MS-460Ci
11/12/08 3:49:04 PM
11/12/08 3:49:04 PM