Conrad 86 10 35 Bedienungsanleitung Seite 6

O P E R A T I N G I N S T R U C T I O N S
Time-lapse Camera
Item no. 86 10 35
Intended Use
The product is intended for long-term observation of e.g. plants. A built-in digital camera takes
one picture at a time at adjustable intervals.
Recording is done using an included SDHC memory card that is inserted inside the device. The
product is operated using 4 batteries of type AA/Mignon.
The product may be installed outdoors using the included ground stake. However, a tripod
socket also allows other attachment options.
This product complies with the applicable national and European requirements. All names of
companies and products are the trademarks of the respective owners. All rights reserved.
Package Contents
• Time-lapse Camera
• Foot (consisting of several components) with ground stake
• SDHC memory card (4GByte)
• CD with software
• 4 batteries of type AA/Mignon
• USB cable
• Operating instructions
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe
these safety instructions. We do not assume any liability for any resulting
damage!
We shall not accept liability for damage to property or personal injury caused
by incorrect handling or non-compliance with the safety instructions. The
warranty will be void in such cases!
• The unauthorised conversion and/or modifi cation of the product is not permitted
for safety and approval reasons (CE). Never take the product apart (except for the
installation/battery replacement tasks described in these operating instructions).
There are no serviceable or adjustable parts inside the product.
Maintenance, settings work or repairs may only be carried out by a specialist/
specialised workshop.
• The product is not a toy and should be kept out of the reach of children. The pro-
duct contains small parts, glass (display) and batteries.
• The product is suitable for use in unprotected outdoor areas. However, it must
never be used in or under water, as this will destroy it.
• Do not expose the product to direct sunlight for a long period. Overheating may
damage the product. Place the product in such a way that it is kept in the shade.
• Observe the statutory regulations relating to the use of the product. Do not use the
product for the surveillance of people or vehicles!
• Do not leave packaging material carelessly lying around, since it could become a
dangerous plaything for children.
• Handle the product with care; it can be damaged by impacts, blows, or accidental
falls, even from a low height.
General information on batteries/rechargeable batteries
• Batteries/rechargeable batteries must be kept out of reach of children.
• Check that the polarity is correct when inserting the batteries/rechargeable batteries
(pay attention to plus and minus).
• Do not leave batteries/rechargeable batteries lying around; they could be swallowed by chil-
dren or pets. If they are swallowed, consult a doctor immediately.
• Leaking or damaged batteries/rechargeable batteries in contact with the skin can cause acid
burns, therefore, use suitable protective gloves.
Liquids leaking from batteries/rechargeable batteries are very chemically aggressive.
Objects or surfaces coming into contact with these liquids might be considerably damaged.
Thus, store batteries/rechargeable batteries in a suitable location.
• Batteries/rechargeable batteries must not be short-circuited, opened or thrown into fi re.
There is a risk of explosion!
• Conventional batteries must not be recharged. Explosion risk! Only charge rechargeable
batteries that are intended for this purpose; use a suitable battery charger.
• Never mix batteries and rechargeable batteries; do not mix normal and rechargeable batter-
www.conrad.com
ies with different charges (e.g. full and half-full batteries). Always use four (rechargeable)
batteries of the same type/manufacturer to power the product.
• For safe and lasting use of the product, we recommend using only high-quality alkaline
Version 04/13
batteries.
Controls
1 Lens (turn to focus)
2 Function LED
3 Tripod/fi xing socket
4 LC display
5 "F" button (operated in the menu, reduce the value)
6 "H" button (menu)
7 "S" button (operated in the menu, increase the value)
8 Battery compartment
9 " " (ON/OFF) button
10 "D" button (start playback)
11 "OK" button (confi rm selection / setting)
12 Mini-USB port
13 Slot for SD/SDHC memory card
Getting Started
• Remove the cover on the rear side.
To do so, shift the fastening slide to the left
position (see arrow on the image) and then
lift up the cover as shown in the image at
right .
Proceed in the opposite manner when reas-
sembling (lower the cover, then close it and
shift the fastening slide to the right position).
• Open the rubber cover for the slot (13) of the
SD/SDHC memory card and insert the included SDHC memory card in the correct position
(the label of the memory card faces the monitor). Push the memory card inside until it clicks
into place.
• Then close the rubber cover carefully.
• Open the battery compartment (8) by pushing its cover upwards. Insert four AA/Mignon
batteries with correct polarity (observe plus/+ and minus/-, see labels on the batteries and
the battery compartment).
The textile strip in the battery compartment must lie under the batteries and will later help in
removing the batteries from the battery compartment easily.
Close the battery compartment again by putting on the battery compartment cover and
pushing it on the edge until it snaps into place.
When using rechargeable batteries, expect a shorter running time due to the lower
operating voltage (normal battery = 1.5 V/cell, rechargeable battery = 1.2 V/cell).
Rechargeable batteries are more temperature sensitive than normal batteries. At
low temperatures, rechargeable batteries have a very short operating time.
However if you set a very short interval (see setup menu, "Time lapse" function), the
batteries may become fl at within a few days! In this case, the rechargeable batteries
are the better choice.
1
4
7
6
5
2
8
3
To remove the memory card, push it into the slot slightly, then release it. Through the
built-in spring mechanism, the memory card is pushed out slightly, whereby it can be
easily removed.
12 13
9
10
11