Cleaning And Maintenance - Clatronic DR 2890 Bedienungsanleitung

5....-05-DR 2890
6. Point the steam nozzle at the surface to be cleaned and press the steam switch
GB
(5).
7. Use the lock (8) to turn the steam pistol to permanent steam.
Filling up the Water Boiler when using the Device
If there is no more water in the vessel no steam is emitted when the steam switch
(5) is pressed. The water has to be filled up as follows:
1. Press the on/off switch (1). The red control lamp goes off.
2. Wait for approximately 5 minutes and release the residual pres-
sure with the steam switch!
3 Pull the power plug out of the socket!
4. Slowly open the safety lock (4) and wait a few seconds before ope-
ning it completely until the overpressure has been released. Note:
For your protection the safety lock has a release device. If the pres-
sure in the kettle is still too high, this release device prevents it from
being opened.
5. Fill freshwater from the measuring beaker (9) into the kettle. Do not
overfill! Do not exceed the quantity of water stated on the measuring
beaker, i.e. 1.2 litres! Take care of water splashes that might come
out of the boiler. In order to prevent water from splashing, the water
should be filled in slowly after the safety lock has been opened.
6. Fasten the safety lock again.
7. Reinsert the plug into the socket and switch on the device using the
on/off switch.
When you have finished using the device
1. Switch the device off using the on/off switch (1).
2. Allow the pressure that is still present to escape by operating the lever on the
steam pistol (16).
3. Switch off the steam control button (19). The green control lamp goes off.
4. Remove the mains plug from the socket.
5. Allow the device to cool down for approximately one hour and then shake out
any residual water that may be present in the kettle (2).
• Cleaning and maintenance must only be carried out when the power plug is
removed from the socket.
• Before putting the device away or cleaning it, it has to be allowed to cool down
completely.
• Please clean the device and the accessories only with a slightly moist cloth.
• Do not use strong cleaning agents of solvents for cleaning.
• In order to guarantee a long and trouble-free working life, lime residues have to
52
24.06.2004 14:04 Uhr

Cleaning and Maintenance

Seite 52