Cleaning And Maintenance - Clatronic DR 2930 Bedienungsanleitung, Garantie

Filling up the Water Boiler when using the Device
GB
If there is no more water in the vessel no steam is emitted when the steam switch
(4) is pressed. The water has to be fi lled up as follows:
1. Pull the power plug out of the socket!
2. Wait for approximately 5 minutes and release the residual pres-
sure with the steam switch!
3. Unscrew the safety lock (3) slowly and wait for a few seconds
before opening it completely until the excess pressure has
escaped.
4. Fill fresh water from the measuring beaker (8) by means of the funnel
into the boiler. Do not overfi ll! Do not exceed the amount of water
indicated on the measuring beaker! Take care of water splashes
that might come out of the boiler. In order to prevent the water from
splashing it should be fi lled into the funnel slowly after the safety
lock has been opened.
5. Fasten the safety lock again.
6. Insert the power plug back into the socket.
• Cleaning and maintenance must only be carried out when the power plug is
removed from the socket.
• Before putting the device away or cleaning it, it has to be allowed to cool
down completely.
• Please clean the device and the accessories only with a slightly moist cloth.
• Do not use strong cleaning agents of solvents for cleaning.
• In order to guarantee a long and trouble-free working life, lime residues have
to be rinsed out of the boiler once a month. Please do not use vinegar or
other anti-liming agents.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
42
6....-05-DR 2930 42

Cleaning and Maintenance

01.10.2004, 14:46:29 Uhr