Hama AT-802 Bedienungsanleitung Seite 14

Displaying and changing the program
storage space:
1. When the device is in manual mode,
hold down the control button to change
to save mode. The last storage space
that has been used is then shown on
the LCD. This display indicates that the
device is now in save mode.
2. Change the program storage space
using the control button. The correspon-
ding frequency is shown on the LCD.
3. To switch from save mode back to
manual mode, hold down the control
button once more. The program storage
space displayed on the LCD is no longer
shown. This indicates that the device is
no longer in save mode. The frequency
that was shown before switching to save
mode appears on the LCD once again.
Note on frequency display:
Please note that two digits of the frequency
are displayed. Frequencies such as
107.9 MHz are displayed as 07.9 MHz.
Backlight:
1. The device has an integrated backlight
so you can also operate the transmitter
in the dark.
2. Press any button to switch on the
backlight for approx. 3 seconds.
3. To save power, the brightness of the
backlight is set so the device can be
operated comfortably in the dark. It
may be diffi cult to see the light in bright
daylight.
Save mode
Save mode
Manual mode
13