Renkforce 91 56 05 Bedienungsanleitung Seite 33

Proceed as follows to properly position and connect the sound system:
• Fold the woofer to the back and position the sound system in the designated
place.
• Make sure that the "ON/OFF" slide switch is in the "OFF" position.
• Connect the low-voltage adapter of the wall power supply to the connection for
power supply "DC IN 10V" (11).
• Connect the wall power supply to a standard household mains socket (230 V/AC
50 Hz).
At the time of printing, it was not clear whether the supplied
remote control battery would already be inserted in the remote
control upon delivery. Therefore, note the following two points:
If the battery has already been inserted into the
remote control upon delivery,
• remove the protective battery foil from the
battery compartment of the remote control
as illustrated on the right (if the foil has not
been removed yet).
If the battery has not been inserted into the
remote control upon delivery,
• open the battery compartment as illustrated
on the right and insert the supplied
3 V/DC coin cell battery (type CR2025) with
the correct polarity (correct polarity is illus-
trated).
• Close the battery compartment.
32
Operating instructions
English