Connecting the power supply
Make sure that, before you connect device to the power supply grid, the operating mode switch
(1) is switched off (position "OFF").
The POWER (1) button does not fully disconnect the device from the mains. In order to
completely separate the device from the electricity net, you have to pull the mains plug out of
the wall socket.
•
Connect the mains plug of the CD player to a socket (230V~/50Hz) linked to the public power supply network.
Operation
1
PO W ER
(1)
POWER button
This button switches the CD player on and off.
Position ON > Device is on, alternatively in standby mode (when switched off by the amplifier A-1000 remote
control) , Position OFF > Device is switched off.
(2)
CD tray
The CD should be placed in the tray with written side facing upwards. Both 80mm and 120mm discs can be
played.
(3)
OPEN/CLOSE button
Press this key to open and close the CD tray (2).
(4)
Display reading
(5)
PLAY/PAUSE button /
This button starts playback Pressing this button again pauses playback (PAUSE) Pressing the button a third
time resumes playback at the point of pause.
2
6
4
O PEN /CLO S E
3
5
8
9
11
ME M OR Y
ME M C LEAR
RE PEAT
IN TR O
7
10
12
23