Setup; Connection - Renkforce CD-1000 Bedienungsanleitung

Setup

When selecting the installation site, consider the room conditions, meaning the location of the next outlet, etc. Also
prevent direct sunlight, vibrations, dust, heat, cold and dampness. Keep the appliance away from strong transformers
or motors.
Operate the device only on a stable, level surface. There must be enough space around the
system for air circulation to permit dissipation of the generated heat. Therefore, only place the
device on a level surface and not on carpets, etc. Do not cover up the ventilation slots in the
casing.
If you do not heed these instructions, the device may be damaged.
Do not drill extra holes or screw any extra screws for mounting purposes into the case. This will
damage the device.
Only operate the CD player in a horizontal position, otherwise it will not function properly. If you
do not heed these instructions, the inserted CD or the CD player may be damaged.
Make sure you position the appliance in a safe and stabile place, away from objects that might
fall on it, thereby avoiding unwanted accidents.

Because of the variety of used lacquers and polishes for furniture, the device base might leave residues
on furniture due to a chemical reaction. That's why do not place the device without appropriate
protection on the valuable furniture surfaces.

Connection

Make sure that, before you connect the device, it is disconnected at the mains. Similarly, all
other devices to be connected should be separated from the electricity supply.

Pay attention to connect property, that is, left always to left and right always to right.
21