Philips SBC LI 800 Bedienungsanleitung Seite 5

TRANSMITTER RANSMITTER
R
SBC LI 800 SBC LI 800
CONTROL EXTENDER
CONTROL EXTENDER
DC 9V
CEIVER EIVER
R
C LI 800 C LI 800
TROL EXTENDER TROL EXTENDER
DC 9V
RECEIVER RECEIVER
R
SBC LI 800 SBC LI 800
EMOTE CONTROL EXTENDER MOTE CONTROL EXTENDER
DC 9V
TUNER
TUNER
CD
CD
DVD
DVD
Contents
Help line 2
General 4
Important information 4
Installation 5
Operation 6
Troubleshooting 7
Installation
The transmitter (SBC LI 802) -
1 Place the transmitter in the room from which you want to control your
equipment.
Position in such a place that it can receive the signals from the remote
control.
2 Connect the adapter supplied to the transmitter and connect the
transmitter to the mains supply (230-240 VAC).
> The green light will light up in the window on the front.
The receiver (SBC LI 805) -
1 Place the receiver in line of sight of the equipment you want to control.
The receiver should be facing the equipment.
2 Connect the adapter supplied to the receiver and connect the receiver to
the mains supply (230-240 VAC).
> The green light will light up in the window on the front.
Extension cord -
1 Connect the extension cord to the receiver and position the receiver
beside or behind the equipment you want to control.
2 Remove the adhesive tape from the IR light(s) and affix the IR light(s) on
the IR sensor(s) of the equipment you wish to control.
Notes:
– The adhesive tape will not damage your equipment.
– For the location of the IR receiver(s) on your equipment, check the appropriate
manuals.
– If the location of the IR receiver(s) is not exactly known you can place the IR
lights 5-10 cm away from the front of the equipment you wish to control.
fig. 1a
fig. 1b
fig. 2
ENGLISH
5