3M PELTOR SportTac MT16H210F serie Handbuch Seite 6

GB
3M™ PELTOR™ SportTac
Hearing protector with level-dependent function for ambient listening and input for exter-
nal equipment. Read these instructions carefully before use and save for future reference.
1. COMPONENTS
A:1 Foldable Headband (stainless steel sheet, TPE)
A:2 Cup supporting arm (stainless steel)
A:3 Two-point fasteners (POM)
A:4 Ear cushion (PVC foil, PUR foam)
A:5 Cup
A:6 Shell
A:7 Shell lock clip
A:8 Microphone for ambient listening function
A:9 On/Off button
A:10 (+) button
A:11 (-) button
A:12 External input jack (J22)
2. FITTING AND ADJUSTMENT
Note! Brush aside hair around your ears so the ear cushions fit snugly. Spectacle frames
should be as thin as possible and fit close to the head to minimize acoustic leakage.
2:1 Foldable headband
(B:1)(B:2) Slide out the cups and tilt the top of the cup out, as the cable must be on the
outside of the headband.
(B:3) Adjust the height of the cups by sliding them up or down while holding the head-
band in place.
(B:4) The headband should be positioned across the top of your head.
(B:5) When small size range is needed for fitting, attach a HY450/1 (available as acces-
sory) on the inside of the headband to fit between the top of the head and the headband.
3. USAGE/FUNCTIONS
3:1 Inserting batteries
Open the right side shell by sliding the clip out/down. Remove the shell. Insert batteries,
(2xAAA) in the battery compartment. Make sure the polarity of the batteries is correct.
Put the shell back in position and slide the clip back up. Low battery level is indicated by a
three tones signal, repeated times with decreased interval.
3:2 Switching the headset on and off
Press and hold the On/Off button for two seconds to switch the headset on or off. A tone
will confirm that the unit has been switched on or off. The last setting is always saved
when the headset is switched off. The headset is automatically powered off after two
hours of no active functions. This is indicated by a tone signals the last minute, then the
headset switches off.
3:3 Volume
The volume of the level-dependent function for ambient listening is continuously adjustable
from min to max. The combined volume of the external input and the ambient listening
function is limited to 82 dB(A) effective to the ear. The amplification of the ambient listening
is toned down when an external signal comes in through the external input. Press and hold
the (+) or (-) button to increase or decrease the volume to preferred setting.
Note! When the ambient listening function is min mode, no ambient sound will not be
attenuated, which could be hazardous.
4. IMPORTANT USER INFORMATION
It is recommended that the wearer ensure that:
• The ear-muffs are fitted, adjusted and maintained in accordance with the
manufacturer's instructions.
• The ear-muffs are worn at all times in noisy surroundings.
6