Herunterladen Diese Seite drucken

Ripmax RC Racing Bedienungsanleitung Seite 2

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

A. Charging from the Transmitter
Remove the charging plug from the bottom of the transmitter. Connect it to the car's charging port
(on the left hand side) to begin the charge process. This will be indicated by an LED which will
remain on for the duration of the charge. Once the LED goes out, charging is complete. You can
now remove the charging plug from the car.
B. Charging via USB
Insert the USB charge lead into a USB port such as that on a computer or mobile phone
charger. The LED will illuminate. Connect the end of the USB lead into the car's charge port. The USB
LED will go out. After approximately one hour, the light will illuminate once more - the charge process is
complete and you may now remove the USB charge plug from the car and from the USB port.
1. The radio equipment used in this model is 2.4GHz, enabling interference free control and the ability to
run more than one vehicle simultaneously.
2. Turn the car on using the switch located on the underside. The LED flashing indicates that the
receiver is looking for a corresponding signal. Switch on the transmitter. The receiver (in the car) will
locate it and the LED will stop flashing and remain illuminated. The transmitter and receiver are now
'bound' together.
3. If, once the receiver and transmitter are bound, the car lurches forwards or backwards, use the throttle
trim function and adjust it so that the car remains stationary when the throttle trigger is centred.
4. The controller has a 5 speed mode. If the '5 Mode' switch is activated, (rather than 'All Scale Mode')
each time you press the increase (top) button, the car's speed will increase in 5km/h intervals.The
LED strip on the side shows which speed level the car is currently at. Pressing down will reduce the
level and consequently the top speed of the car.
5. Use the steering trim to ensure the car runs in a straight line when the steering wheel is released.
6. Should the 'Full Scale Mode' switch be selected, the 5 Speed Mode is disabled and the car will have
unrestricted speed, from stationary to full speed, controlled by the throttle trigger.
Power Switch
Shift Up
Power Indicator
Mode Conversion Switch
Charging Light
Aerial
Gear Indicator LEDs
Steering Wheel
Throttle/Reverse Trigger
Forward/Reverse Trim
Charge Port
Steering Trim

Werbung

loading