Clearaudio Satisfy Carbon Silver DW Montageanleitung Seite 7

Azimuth adjustments are facilitated through the small (1,5 mm) allen screw (red marked
screw) on the bottom side of the armwand where the headshell enters the carbon fibre.
Once you loosen this screw, you´ll be able to rotate the headshell a small amount in either
direction. Be sure to tighten the screw when done.
Picture 6: Azimuth adjustment
Wind the counterweight on the tonearm-tube. You can adjust the tracking force of your
cartridge by turning the counterweight (shown in the picture below)
(green arrow = more tracking force
Page / Seite 7
/ red arrow = lesser tracking
Picture 8: Tracking force adjustment
Satisfy
User manual / Bedienungsanleitung
Picture 7: Screw to adjust the
headshell
force).
 clearaudio electronic GmbH 2014