Werbung
Verfügbare Sprachen
Verfügbare Sprachen
receiver is placed in the location where it will be used most of the time.
Installation Warnings
Aim the camera(s) to best optimize the viewing area: Select a location for the camera that provides a
clear view of the area you want to monitor, which is free from dust, and is not in line-of-sight to a strong
light source or direct sunlight.
Avoid installing the cameras where there are thick walls, or obstructions between the Cameras and the
Receiver.
Night Vision
This camera has built-in IR LEDs , which provides the camera with the ability to view images in no/low
light conditions.
Installing the Camera
1. Carefully unpack the camera.
NOTE: If you are installing cameras that did
not come with the system, please see the
pairing camera section of this manual for
details on
installation.
2. Mount the camera to the wall.
Mark the position of the screw holes on the
wall, and drill holes and insert 3 screws, then
firmly attach the camera to the wall. Make
sure to strongly secure the screw the mounting bracket into the wall
NOTE: The camera can also be placed on a flat surface, such as a Table or Shelf, and no mounting
hardware is required.
3. Adjust the viewing angle of the camera. You can adjust camera angle to desired viewing area.
NOTE: You can install additional cameras (maximum of 4 cameras). When adding cameras that were not
included in the original box, you will need to pair up the cameras with the receiver. Refer to the camera pairing
section of this manual.
Connecting Camera Power
The camera can be powered by using the provided power adaptor
Power Adaptor
Connect the power adaptor to the camera.
Make sure is the DC 9V for camera, and DC 5V for Receiver
Make sure the power adaptor is placed into a grounded outlet or surge bar to protect the camera from
power fluctuations.
Werbung
