Camera Installation - Eufab 16227 Bedienungsanleitung

BLUE LED Power Indicator
When the monitor is ON the blue LED will be lit. If there is power to the monitor, but the
monitor is OFF, the blue LED will be OFF.
Power Button
Press the Power button to turn the display ON, the blue LED will be lit to indicate the
monitor is ON. Press it again to turn the display OFF, the blue LED will turn off.
Brightness Control
There are 13 levels of brightness. To adjust the brightness, press the Brightness Control
button. Pressing the button to increase the brightness at the highest level will return to
the lowest level.
Contrast Control
There are 13 levels of contrast. To adjust the contrast, press the Contrast Control button.
Pressing the button to increase the contrast at the highest level will return to the lowest
level.
Image Orientation Control
Press this button to reverse the angle of the camera.

CAMERA INSTALLATION

You may mount the camera using the license plate's top or bottom mounting bolts or
screws. Make sure that it's field of view is not obstructed. Use the supplied wedge
shaped shims to adjust the angle that the camera is mounted.
At some type of cars it is not possible to mount the camera to the license plate. You may
have to find another spot at the back of your car to mount the camera with the supplied
bolts and screws.
1. Loosen the license plate bolts/screws, and then remove the rear license plate.
2. Insert each license plate bolt into a supplied wedge, then through the bolt holes of
the camera, then through the remaining wedges and the license plate (picture).
9