Eufab 16227 Bedienungsanleitung Seite 10

The power cable attached to the camera should be on top (if for installation it is
easier to have the camera's power cable at the bottom, the monitor inside your car
should be upside down as well).
3. Align with holes on vehicle and temporarily tighten the license plate bolts/screws.
The wedges will angle the camera down.
4. You will need to choose a route for the camera's power cable through the vehicle's
body to the reverse light circuit.
5. Some vehicles may have a hole available to pass the wire through, such as where
the license plate light is mounted, or you can drill a hole close to where the power
cable is attached to the camera. Once you have chosen where the cable will enter
the vehicle's body, remove the camera.
If you are able to use an existing opening, skip the next two steps.
6. Before you drill a hole you MUST CHECK and see WHAT IS BEHIND WHERE YOU ARE
DRILLING. If there are any vehicle components, such as electrical parts or fuel system
components behind where you are drilling, you must take whatever precaution is
necessary not to damage them. Remove the license plate and camera before
drilling.
7. After you have drilled a hole, insert the supplied grommet, then pass the camera
cables through the grommet into the vehicle. You must use the grommet to
prevent the metal edge of the hole from cutting the camera cable.
8. Mount the transmitter box inside the trunk. Connect the camera's power cable and
the transmitter box power cable to the transmitter box.
9. Next you'll need to find the vehicle's reverse lights. Turn the vehicle's ignition key
to the accessory position, engage the parking brake and put the car in reverse.
Look at the vehicle's tail lights to see where the reverse lights are located, they are
the white lights.
To locate the reverse light's 12V+ wire it will be necessary to gain access to the rear
of the vehicle's tail light.
For help locating the vehicle's reverse light circuit contact your vehicle's
manufacturer for vehicle specific wiring diagrams.
10. Once you have located the reverse light circuit you will have to route the transmitter
box power cable to that location. You must securely fasten the power cable to
prevent it from being caught on any vehicle component such as the trunk hinge.
NEVER ROUTE THE CABLE ON THE OUTSIDE OF THE VEHICLE!
11. The reverse light sockets on most vehicles have two wires connected to them.
Usually the negative wire is black and the positive wire is a colored wire. If you are
uncertain about the wiring, you can use a 12 volt multimeter available at most auto
parts stores to determine which is the positive wire. Follow the manufacturer's
instructions for the safe use of the multimeter.
12. After determining which wire is the positive and which is the negative, turn off the
ignition key, then remove the battery's negative cable.
13. Splice the red wire using the supplied in-line wire connectors to the reverse light's
positive (+) wire. Use a set of slip joint pliers to squeeze the TAP and insure good
connection.
10