Initial Operation - VOLTCRAFT DSO 4022 Kurzanleitung

Initial Operation

Connect the mains cable provided to the mains connector, at the back of the device, and con-
nect the Schuko plug to an earthed mains socket.
Switch on the device with the power switch (POWER I/0).
The device shows a start screen and is ready for operation after a short initialisation phase.
Connect the appropriate measuring cables/probes to the BNC connector of the input channel(s)
A or/and B.
The measuring voltage should only be applied to the internal conductor. The
external conductor (reference earth) is connected to the earth potential (protec-
tive earth conductor).
Touch the object to be measured with the probes.
To automatically set the signal, push the button „AUTOSET".
This function sets the time base, the vertical deflection and the trigger level automatically to opti-
mise the signal visualisation on the oscilloscope.
Remove the probe from the object, after finishing the measurement, and turn off the device.
Cleaning
Always observe the following safety instructions before cleaning the device:
Live components may be exposed if covers are opened or parts are removed
(unless this can be done without tools).
Prior to cleaning or repairing of the device, all cables have to be detached and
the device has to be turned off.
Do not use scouring, chemical or aggressive cleaning agents such as benzene, alcohol or such
like. These might attack the surface of the device. The fumes are furthermore a health hazard and
are explosive. Moreover, you should not use sharp-edged tools, screwdrivers or metal brushes or
similar for cleaning.
For cleaning the device or the display and the measuring cables, use a clean, slightly damp, fuzz-
free, antistatic cloth.
Should questions arise concerning the use of the device, feel free to contact our
technical support at the following phone number:
Voltcraft®, 92242 Hirschau, Lindenweg 15,
Phone 0180 / 586 582 723 8
Disposal
Electronic products are raw material and do not belong in the household waste. When
the device has reached the end of its service life, dispose of it in accordance with the
current statutory regulations at the communal collection points.
Disposal in domestic waste is not permitted.
You thus fulfil the legal requirements and make your contribution to protecting the environment!
These operating instructions are published by Voltcraft
92242 Hirschau/Germany, Lindenweg 15, Phone +49 180/586 582 723 8.
The operating instructions reflect the current technical specifications at time of
print. We reserve the right to change the technical or physical specifications.
© Copyright 2007 by Voltcraft®. Printed in Germany.
® ,