Naming The Model; Selecting Swashplate Type; Servo Setup - Spektrum DX8 Bedienungsanleitung

To Access the Model Type function
Press and hold the roller while turning on the transmitter. When System Setup
appears on the screen, release the roller. The DX8 is now in System Setup Mode.
Highlight Model Type then press the roller to access the function. The following
screen appears.
Highlight the desired model type (helicopter) then press the roller to select. The
following screen appears. Now press yes to accept the model type.
StEP #3

NAMING THE MODEl

The Model Name function allows you to name a model using up to 10 characters.
The model name appears on the main screen and in the Model Select screen
allowing for easy identification.
To Access the Model Name function
In the System Setup list, highlight Model Name then press the roller to access the
function. The following screen appears.
SPEKTRUM DX8 • PROGRAMMING GUIDE
Highlight the desired character then press the roller to access. Rotate the roller to
select the character then press the roller to accept. Repeat until complete.
StEP #4

SElECTING SWASHPlATE TyPE

In the Swash Type screen you can program the swashplate mix to match your
helicopter swashplate type. In this case we use a 3-servo 120-degree swashplate
mix.
To Access the Swash Type function
In the System setup list highlight Swash Type then press the roller to access. The
following screen appears:
Highlight the current swashplate type then press the roller to access. Now rotate
the roller to select the desired swashplate mix—
3 servo 120*. Press the roller to select the type.
StEP #5

SERVO SETUP

Within the Servo Setup function you can adjust the servo reverse, speed, travel
adjust and sub-trim. A servo monitor provides easy visual reference when making
adjustments.
To Access the Reverse function
With the transmitter on and the main or telemetry screen displayed, press the
roller. The Function list displays.
EN
11