Apm Configuration; Network Stack Configuration; Hdd/Ssd Smart Information; Usb Configuration - Asus PRIME Z370-A Serie Bedienungsanleitung

3.6.9

APM Configuration

The items in this menu allow you to set system wake and sleep settings.
ErP Ready [Disabled]
This item allows you to switch off some power at S4+S5 or S5 to get the system ready for
ErP requirement. When set to [Enabled], all other PME options are switched off.
Configuration options: [Disabled] [Enable(S4+S5)] [Enable(S5)]
3.6.10

Network Stack Configuration

The items in this menu allow you to configure Ipv4 / Ipv6 PXE support.
3.6.11

HDD/SSD SMART Information

This menu displays the SMART information of the connected devices.
NVM Express devices do not support SMART information.
3.6.12

USB Configuration

The items in this menu allow you to change the USB-related features.
The Mass Storage Devices item shows the auto-detected values. If no USB device is
detected, the item shows None.
USB Single Port Control
This item allows you to enable or disable the individual USB ports.
Refer to section 1.1.2 Motherboard layout for the location of the USB ports.
3-20
Chapter 3: BIOS Setup