9.5 determination of the Shape of the flow Channel
In setup mode, push "Unit
Push "Avg/Rec" to conform your selection.
Use the buttons "Unit
" or "Unit
Push "Avg/Rec" to conform your selection.
9.6 Setting the flow Channel Parameters
rectangular flow Channel
" or "Unit
", until "duct shape" appears in the lower area of the display.
" to select the round or square icon for a rectangular or round flow channel.
If the flow channel is rectangular, the display first shows "W=" and a number that indicates the
width of the channel in the selected measuring units.
Display "DECI": Push "Unit
Push "Save/Clear" to switch between decimal points – the currently selected number flashes.
"Unit
" or "Unit
(0 ... 9).
Push "Avg/Rec" to conform your selection.
The display now switches to "H=" and shows the height of the channel in the desired measur-
ing unit.
Display "DECI": Push the "Unit
Push "Save/Clear" to switch between decimal points – the currently selected number flashes.
"Unit
" or "Unit
(0 ... 9).
Push "Avg/Rec" to confirm your selection and save the settings.
" or "Unit
", to determine the position of the decimal point.
" can now be used to set the individual numbers according to your wishes
" or "Unit
", to determine the position of the decimal point.
" now can be used to set the individual numbers according to your wishes
27