Operating Controls - VOLTCRAFT VSP 1220 Bedienungsanleitung

Any use other than that described above damages the product. Moreover, this is linked to dangers such
as short circuits, fire, electric shock, etc. No part of the product may be modified or rebuilt!
Observe the safety instructions under all circumstances!

Operating Controls

see fold-out page
(1) Power switch for putting the device into operation (I=ON / 0=OFF)
(2) Power indicator
(3) LC display (in short: "display") for output A
(4) Status display output A (CV = constant voltage, OT = overtemperature, CC = current limit)
(5) Button "C-limit" to display and set the current limitation of output A
(6) Overload display for output B (current limiting is activated)
(7) Control for the voltage of output B
(8) Push button for voltage and current display of output B on the display of output A (3)
(9) Connection socket negative of output B
(10) Connection socket positive of output B
(11) Connection socket "Ground potential"
(12) Current adjuster for output A (coarse/fine)
(13) Voltage adjuster for output A (coarse/fine)
(14) Connection socket negative of output A
(15) Connection socket positive of output A
(16) Feet on the front side, extendable
(17) Fuse holder for the mains fuse
(18) Grounded low-power connection for mains cable
(19) Terminal strip for remote control and sense connection output A
20