Operating Elements - VOLTCRAFT LSP-1403 Bedienungsanleitung

Operating elements

(see fold-out page)
(1) Power switch for putting the device into operation (I=ON / 0=OFF)
(2) UVL button for activating the limit setting
(3) REVIEW button for displaying the voltage and current setting
(4) Range selection buttons for the corresponding DC output range
(5) OUTPUT ON button for activating and deactivating the DC output
(6) SLAVE status display is lit in slave operation
(7) LED display for the current strength „Ampere"
(8) LED display for the voltage „Volt"
(9) UVL status display with active UVL limit setting
(10) C.V. status display for constant voltage
(11) C.C. status display in case of active current limitation
(12) ALM status display in case of deactivated output due to UVL limit setting
(13) Adjuster for the voltage
(14) Adjuster for the current limitation (max. admissible current)
(15) Adjustment position for the UVL limit value (with activated UVL limit setting)
(16) Connection socket positive pole
(17) Connection socket negative pole
(18) Plug-in clamp for sense line for remote sensing, positive pole
(19) Plug-in clamp for alternative DC output, positive pole
(20) Plug-in clamp for alternative DC output, negative pole
(21) Plug-in clamp for sense line for remote sensing, negative pole
(22) Plug-in clamp for master operation output
(23) Plug-in clamp for slave operation input
(24) Master-slave conversion switch
(25) Grounded low-power connection for mains cable
20