Operating Elements - VOLTCRAFT VSP 2206 Bedienungsanleitung

Operating Elements

see fold-out page
(1) Power switch for putting the device into operation (I=ON / 0=OFF)
(2) Power indicator
(3) LC display (in short: "display") for output A
(4) Status display output A (CV = constant voltage, OT = overtemperature, CC = current limit)
(5) Selection switch "series tracking" for series switching of output A & B. Both outputs are controlled
via the "master" control of output A
(6) Selection switch "series" for serial switching of output A & B (voltage doubling). Separate control.
(7) Selection switch "parallel" for parallel switching of output A & B (electric current doubling).
Voltage control for either output is performed by the "master" control for output A.
(8) Selection switch "individual". Each output can be set independently.
(9) Status display output B (CV = constant voltage, OT = overtemperature, CC = current limit)
(10) LC display (in short: "display") for output B
(11) Overload display for output C (current limiting is activated)
(12) Control for the voltage of output C
(13) Push button for voltage and current display of output C on the display of output B (10)
(14) Connection socket negative of output C
(15) Connection socket positive of output C
(16) Connection socket negative of output B
(17) Connection socket positive of output B
(18) Current adjuster for output B (coarse/fine)
(19) Voltage adjuster for output B (coarse/fine)
(20) Connection socket "Ground potential"
(21) Current adjuster for output A (coarse/fine)
(22) Voltage adjuster for output A (coarse/fine)
(23) Connection socket negative of output A
(24) Connection socket positive of output A
(25) Feet on the front side, extendable
(26) Fuse holder for the mains fuse
(27) Grounded low-power connection for mains cable
(28) Terminal strip for remote control and sense connection output B
(29) Terminal strip for remote control and sense connection output A
(30) "C-limit" button for display and setting of the current limitation of output A
(31) "C-limit" button for display and setting of the current limitation of output B
24