Notes On Use - Panasonic TY-SP42PM3W Bedienungsanleitung

3. Attach the speakers to the
Wide Plasma Display.
slo,
Rear o fW_de P lasma D isplay
H
• Insertthe hookson the top and bottommounting
brackets simultaneouslyinto the slots at the rear
of the Wide Plasma Display,and then lower the
speaker intoplace.
• Attachthe leftspeaker in the same way.
4. Secure the speakers in
place.
Bracket mounting
Rear o fWide Rasma Display
• Adjust so that there is a uniform clearance
between the Wide Plasma Display and the
speakers, and then securely tighten the bracket
mounting screws.
• Secure the top and bottom mounting brackets by
tightening the bracket mounting screws.
• Secure the left speaker in the same way.
5. Connect the speaker cables.
Preparing the ends of the
speaker cables
_--* While tw[s_ng
4-
For 42" Dl_lay
1. Press down on 61e lever.
[L_ 2. Insert
the cable.
L ii1,1. 3. Release the lever.
For 50" IDisplay
t-
o(/)
t-
LU
• After preparingthe ends of the speaker cables, connectthem as shown,
• Connect the speaker cable for the left speaker in the same way.
• The red cable is for the (+) side and the black cable is for the (-) side. Do not connect the cablesto the wrong sides.
When these speakers are attached to the plasma display,they willnot form a straight line but rather so that
they slightlyface inward,to producestable sounds.
Notes on use
1. If connectingto an external amplifier which exceeds the
rated input for the speakers, lower the amplifiervolume to
protect the speakers from damage. If any problems occur
with speaker operation, disconnectthe mains lead of the
amplifierand consulta qualified service technician.
2. Do not peacethe speakers in the following places:
• Places which are exposed to direct sunlight
• Near heaters or other heat sources
• Places with high humidity
3. This set is equipped with magnetic resistantspeakers but
be careful notto place them near the CRT TV as it may
cause colorpatches.
4. To clean the speakers, wipe them with a soft cloth, if they
are extremely dirty, wipe them with a cloth which has been
soaked in a small amount of household detergent, and then
wipe the dry with a separate cloth.
• Do not use solventssuch as alcohol or thinner.
• If usingchemically-treatedcloths, follow the instructions
on the cloth packaging.
5. Remove the dust on the speaker net usinga duster or a
vacuum cleaner at low power. Since the net is made of
cloth, pushing too hard on it may damage the net.
3