Panasonic TY-SP42PM3W Bedienungsanleitung Seite 19

3. Attach the speakers to the
Wide Plasma Display.
ho_e
ooking hole
Rear_1 _de Plasma D isplay
• Set the hooks on the top and bottom mounting
brackets simultaneously into the hooking holes at
the rear of the Wide Plasma Display, and then
lower the speaker into place.
• Attach the left speaker in the same way.
4. Secure the speakers in
place.
Bracket mounting
!_iiii
Rear of_1de Rasma Disl_ay
• Adjust SO that there is a uniform clearance
between the Wide Plasma Display and the
speakers, and then securely tighten the bracket
mounting screws.
• Secure the top and bottom mounting brackets by
tightening the bracket mounting screws.
• Secure the left speaker in the same way.
5. Connect the speaker cables.
Preparing the ends of the
speaker cables
41-
FOe 42" Display
" 1. Pr6ss _n o_11he leve_
II
For 50" Display
" 1, Push down the lever.
the _1_.
i 8 3. Retumtheleverto
its nom_al position.
• After prepadng the ends of the speaker cables, connecttnem as shown.
• Connect the speaker cable for the left speaker in the same way.
• The red cable is for the (+) side and the black cable is for the (-) side. Do not connect the cables to the wrong sides.
When these speakers are attached to the plasma display,they will not form a straightline but rather so that
they slightly face inward, to produce stable sounds.
Notes on use
1. If high volumes which exceed the rated inputfor the
speakers are to be applied, lower the volume of the
amplifierto protect the speakers from damage. If any
problems occur with speaker operation, disconnectthe
power cord of the amplifierand consult a qualified service
technician.
2. Do not place the speakers in the followingplaces:
• Places which are exposed to direct sunlight
• Near heaters or other heat sources
• Places with high humidity
3. This set is equipped with magnetic resistantspeakers but
be careful not to place them near the CRT TV as it may
cause color patches.
4. To clean the speakers, wipe them with a soft cloth. If they
are extremely dirty, wipe them with a cloth which has been
soaked in a small amount of householddetergent, and then
wipe the dry with a separate cloth.
• Do not use solvents such as alcohol or thinner.
• If using chemically-treatedcloths, follow the instructions
on the cloth packaging.
5. Remove the dust on the speaker net using a dusteror a
vacuum cleaner at low power. Since the net is made of
cloth,pushing too hard on it may damage the net.
.__
_'_
19