Practical Advice - Bosch Gluey Originalbetriebsanleitung

Gluey_innen_160992A3XZ_001.indd 15 Gluey_innen_160992A3XZ_001.indd 15
Note: The glue pen will switch itself off automatically after a
few minutes to save energy.
Place the glue pen down in a safe place after use and
let it cool down completely before packing it away.
The hot nozzle can cause damage.

Practical advice

Keep people and animals away from the hot adhesive
and the nozzle tip. Adhesive and nozzle tip will heat up to
150 °C, posing a risk of burns. If hot adhesive comes into
contact with skin, immediately hold the affected area
under a stream of cold water for several minutes. Do not
try to remove the hot adhesive from the skin.
Only use adhesives that have been recommended by the
manufacturer of the glue pen.
Only use low-temperature glue sticks (with melting points of
between 110 and 150 °C). Do not use glue sticks intended
for high gluing temperatures (170–200 °C).
Adhesive bonds can become unstuck when they are affected
by moisture.
Preparing for gluing
The bonding locations must be clean, dry and free from
grease.
The materials to be glued together and the work surface
must not be easily ignited or flammable.
Test whether heat-sensitive materials are suitable before-
hand on a sample workpiece.
The ambient temperature and the workpieces to be glued
must not be colder than +5 °C and not warmer than +50 °C.
Materials that cool the adhesive down quickly should be
warmed first with a hot air gun.
Gluing (see image A)
To open the glue stick compartment, push the slider (5) in
the direction of
material in the glue stick compartment (4)
Switch the glue pen on and allow it to heat up. The light-up
ring (6) will flash slowly.
As soon as the light-up ring (6) is continuously lit up, the glue
pen is ready to use.
Move the slider (5) in direction
deliver the adhesive. If the slider hits the front end, the glue
stick (3) has been used up. Insert a new glue stick.
Apply the adhesive to one side (see "Application tips",
page 16).
Press the materials you wish to glue together against each
other for around 10 to 30 seconds immediately after apply-
ing the adhesive. Correcting the bonding location is still pos-
sible at this point.
The bond is stable after approx. two minutes of cooling time.
Make sure you do not come into contact with the hot
adhesive. Use a silicone mat to press permeable materi-
als together.
Bosch Power Tools
. Insert the glue stick (3) suited to the
with moderate pressure to
English | 15
.
1 609 92A 3XZ | (9.3.18)
09.03.2018 12:52:22 09.03.2018 12:52:22