Technical Data - Klauke SDK 502 Bedienungsanleitung

Instruction manual SDK502
__________________________________________________________________________
3.) Bring the cutting head into a proper cutting position. The blades should cut the cable
in a vertical position to avoid undesired shearing forces.
4.) Actuate the pump until the blades completely overlap and the cable is fully cut.
5.2. Explanation of the application range
The hydraulic cutting tool type SDK502 is able to cut copper as well as aluminium cables
and conductors even with a mild led fortification.
Attention
Do not cut cables or conductors with a steel enforcement.
Attention
This tool is not insulated. Do not use on or near energised electrical lines.
Before starting to cut please make sure that all parts involved in the cutting process are
not connected to live circuits.
5.3. Service and maintenance instruction
The hydraulic tool must be cleaned and dried after each use. The unit is basically
maintenance free, only the joints must be lubricated regularly and the tool has to be
inspected for possible damages and wear.
The hydraulic hose (Pos.-No. 5) and the armature must be checked for damage and
leakage.

6. Technical Data

Cutting range:
Weight:
max. operation pressure:
Hydraulic oil:
Temperaturrange
of the hydraulic oil:
necessary oil volume of the pump: min. 1 l
Symbols
Safety warnings
Please do not disregard these instructions in order to avoid human injuries and
environmental damages.
Operational warnings
I
Please do not disregard them to avoid damaging the pump unit.
Note
Additional copies of this instruction manual are available upon request. The part # is
HE.8226_C.
50 mm Ø
approx. 4,6 kg
700 bar
"Shell Tellus T 15"
-20°C to +40°C
page 9