Gastros Switzerland InductWarm 130+ Undercounter Betriebs- Und Montageanleitung Seite 21

• Using the external Control Unit (optional)
Repeated pressing of the power selection button lets you cycle through the different warming
zones 1, 2, 3, 4 and "OFF".
• Using the Infrared Remote Control (optional)
Repeated pressing of the power selection button lets you cycle through the different warming zones
(„off" > „1" > „2" > „3" > „4" > „off" ...). The IR-remote must target the IR-receiver of the external
control unit or directly the device itself (approx. 30cm).
The InductWarm 130+ has four different power levels, covering different temperature ranges. The final
®
temperature in the pot/pan very much depends on the following factors:
• Quality of the material of the pan (e.g. flat bottom)
• Quality of the inductive layer of the pan
• Consistency of the food, surrounding temperature
• Pot size
• Position of the pot on the induction unit
LED-Status
LED 1 flashing slow
LED 1 illuminated
LED 2 illuminated
LED 3 illuminated
LED 4 illuminated
LEDs are flashing fast
The InductWarm 130+ has an integrated pot detection that guaranties that the induction unit is active
®
only if there is a pot placed on the device. If a pot is detected, the power level can be controlled by
pushing the power selection button either on the device or on the external control panel.
Function
Unit in standby mode
Powel Level 1
Powel Level 2
Powel Level 3
Powel Level 4
No pot detected on the unit
21