Wolf MGK-2-390 Montageanleitung Seite 8

Install the new condensate tray
• Apply a thick bead of silicone around the tray.
There will be 3mm of play between the pan and heat
exchanger which must be filled with silicone.
Install the condensate pan and equipment in reverse order
Installing the flue gas pressure switch
Remove the black cap from the hose nipple.
• Connect the hose nipple to the silicone hose of the
flue gas pressure switch.
Installing the flue gas temperature sensor
• Install the adapter for the flue gas temperature
sensor in the condensate pan using the appropriate
O-ring.
• Remove the flue gas temperature sensor from the
old condensate pan and install it in the new conden-
sate pan.
Fit the filled siphon to the condensate pan
connector
Check:
- Check for gas leaks after installation
- There is a risk of poisoning from gas leaks if installed incorrectly
8
Changing the condensate pan MGK(-2)-390-1000
3065732_201806