Wolf MGK-2-390 Montageanleitung Seite 7

Removing the condensate pan
- Put the jacks in place. At the front beneath the return
pipe. Beneath the connecting rod.
- Remove the screws on the gas pipe (1).
- Remove the 2 or 3 connecting screws on the top 2
crosspieces.
- Raise carefully (at least 3mm) until the silicone seam
of the pan tears. If the heat exchanger still cannot be
raised, drain the heating water from the boiler and
remove all screws from the flow and return pipes (2).
- Remove crosspieces beneath the condensate pan.
- Screw heads are located within the crosspieces (3).
(1)
- The pan can now be removed downwards in the
direction of the gas/air mixture.
Clean the heat exchanger contact surfaces
• Remove any remaining silicone from the heat ex-
changer
1. Silicone remnants removed with blade
2. Clean with silicone remover
3. Roughen surface with sandpaper
3065732_201806
Changing the condensate pan MGK(-2)-390-1000
(2)
(3)
Jack beneath return pipe
Jack beneath connecting rod
Note:
The condensate pan is fixed in place using 3cm long
grub screws
7