Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ftæ
lmoortant:
'J'€t
Dànages
caused
by
the
disregard
of
this
user
manual
are
not subject
to wananty.
The
dealer
will
not accept liability for
any
resulting defects
or
problems.
Please make sure that there are no obvious transport damages. Should you notice any damages on the A/C
connection cable or on
the
casing,
do
not take
the device
into operation
and
immediâtely consult
your
local
dealer.
lf the device has
been exposed
to
drastic temperature fluctuation (e.9. after transportation),
do
not
switch
it
on
immediately.
The
arising condensation
water
might
damage your device.
Leave
the
device
switched off
until
it
has reached room temperature.
This device falls under protection-class
ll
and features
a
protective insulation. The voltage and
frequency
must exactly
be the
same
as
stated
on the
device. Wrong voltages
or
power outlets
can
lead
to
the
destruction of the device and to morlal electrical shock.
Always plug
in
the power
plug last.
The
power
plug must always be
inserted without
force.
Make sure
lhat
the plug
is
tightly connected with the outlet.
Never let the
power-cord
come into contact with other cables! Handle the
power-cord
and all
connections
with the
mains
with
particular caution! Never touch them
with wet
hands,
as
ihis
could lead
to
mortâl
electrical shock.
Never modifu, bend, strain mechanically, put pressure on, pull or heat up
the
power
cord.
Never operate
nexl
to sources of heat or cold. Disregard can lead
to
power cord damages, fire or mortal electrical shock.
The cable insôrt or the female part in the device must never be strained. There must always be
sufficient
cable
to
the device. Otherwise, the cable may be damaged which may lead to mortal damage.
lf
extension
cords
are
used, make sure
that the
core
diameter
is
sufficient
for the
required
power
consumption
of the device. All wamings conc€rning the power cords are also valid
for
possible
extension
cords.
Make sure that the available voltage
is
not higher than stated on the technical sticker.
Make sure that the power-cord
is
never crimped
or
damaged
by
sharp edges. Check the device and lhe
power-cord from time to time.
Always disconnect from
the
mains, when the device
is noi in
use
or
before cleaning
it.
Only handle
the
power-cord by
the
plug. Never pull out
the
plug by tugging
the
power-cord. Otherwise, the
cable
or plug can
be damaged
leading
lo
mortal electrical
shock. lf the power
plug
or the
power switch
is
not accessible, the
device must be disconnected via the mains.
lf the power plug or the device
is
dusty,
the
device must be taken out of operation, disconnêcted and
then
be
cleaned
with
a
dry cloth. Dust can reduce
the
insulation
which may lead
to
mortal electrical shock.
More
severe dirt in and
at
the device should only be removed by a specialist.
There must never enter any liquid into power outlets, extension cords
or
any holes in
the
housing
of
the
device- lf you suppose that also a minimal amount of liquid may have entered the device,
it
must immediately
be disconnected. This is also valid, if the device was exposed
to
high humidity. Also
if
the device is
still
running,
the
device must
be
checked
by
a
speciâlist
if
the
liquid
has
reduced
any
insulation.
Reduced
insulation can cause mortal electrical shock,
There must n€ver be any objects entering into the device. This is especially valid
for
metal parts. lf any metal
parts like staples or coarse metal chips
enter
into
the
device, the
device
must be taken
out
of
opelation
and
disconnected immediately. Malfunction or short-circuits caused by metal parts may cause mortal injuries.
9t12
00047288.DOc,
Version 1.0
Werbung
Inhaltsverzeichnis
