Using The Appliance - Clatronic FR 3698 H Bedienungsanleitung

Notes for Use
Location
• Set the appliance onto a non-slip, level, and heat-resist-
ant surface.
• Take care that the appliance and the mains cable never
are placed onto hot surfaces or near heat sources (e. g.
range, hob).
Electric Connection
Before inserting the power plug into the outlet, check that
the mains voltage to be used matches that of the appliance.
You can find the required information on the nameplate.
Switching the Appliance On / Off
• The appliance is switched off if the timer is set to the
0 position.
• Operation is only possible if the fat tank is used with the
basket in the appliance.
• To use the appliance, set the desired time with the timer.
And set the desired temperature with the temperature
controller.
NOTE:
Once the time is up, a bell will sound. The appliance will
switch off automatically.
Before Initial Use
• There is a protective layer on the heating element. To
remove this, operate the appliance for about 10 minutes
without any contents.
NOTE:
Any smoke or smells produced during this procedure
are normal. Please ensure sufficient ventilation.
•
WARNING:
Allow the appliance to cool down before you clean it!
- Disconnect the mains plug from the wall socket.
- Before using the appliance, wipe out the basket, the
fat tank and its interior.
Useful Hints for Use
• This appliance is used for the preparation of solid foods.
Do not prepare any soups or liquid foodstuffs in it.
• A safety switch prevents the use of the appliance without
a basket with the fat tank.
• To achieve an optimum result, fill the basket at most up
to the MAX marking. Never overfill the basket, so that
the food does not touch the heating element.
• Never put oil or other liquids in the fat tank. In order to
achieve crispy results, you can baste the food with a
little oil.
• Do not prepare the appliance for high-fat foods (e. g.
sausages).
36
FR3698H_IM
• All foods can be prepared in the appliance, which are
also suitable for the oven.
• Note that the dough expands during baking of cakes,
bread or similar. Nothing must come into contact with
the heating element.
• Foods that are cooked over one another, must be
shaken after half way through the cooking time. Thus
the result is optimized and prevents uneven cooking.
• Pour water on homemade potato products after cutting
at least 30 minutes to reduce the potato starch. Then dry
the potato pieces with paper.
• The cooking time depends on several factors: Size,
condition, quantity of food and set temperature. For
standard values, see "Table of cooking times".
• If you do not preheat the hot air fryer, add 5 minutes to
the cooking time.
• Fry steaks / larger quantities of meat in a pan previously
before leaving to cook in the hot air fryer. Time and
temperature are dependent on the desired degree of
doneness.
• With the appliance, you can also reheat food. Set the
timer to 10 minutes and the temperature control to
150 °C.

Using the Appliance

1. Connect the appliance to a properly installed earthed
socket.
2. Turn on the appliance with the switch. The indicator light
shines. You can select a cooking time.
3. Turn the temperature controller to the desired temper-
ature.
NOTE:
Preheat the appliance for approx. 5 minutes.
4. Using the handle, pull the fat tank with the basket from
the appliance.
5. Place the fat tank with basket on a heat-resistant surface.
6. Fill the basket with the desired food.
7. Slide the fat tank with the basket back into the appli-
ance. It must engage.
8. If necessary, shake the food after half the cooking time.
Pull it out of the fat tank with the basket on the handle.
WARNING:
• Hot steam can escape!
• Never shake the basket when it is in the fat tank,
because this may contain hot oil.
9. Place the fat tank with basket on a heat-resistant
surface.
10. Slide the cover of the release button towards the basket.
11. Press the release button to remove the basket. Shake
the contents of the basket.
12. Put the basket back in the fat tank. This must engage.
13. Slide the fat tank back into the appliance.
09.04.18