Troubleshooting - Revell Control Rapid Hero Bedienungsanleitung

4 start prEparation
The remote control of the vehicle
switches on automatically when the
buttons are actuated. To switch on the
model, set the switch (1D) on the
underside of the vehicle to ON (4A).
The ON/OFF switch (1D) on the model
must be set to OFF after use. Otherwise,
a drive command can accidentally be
triggered, causing the vehicle to drive
away on its own, which can lead to
considerable damage.
Attention: The antenna tube must be in-
stalled before the first trip. Slide the tube
over the antenna cable, pull the cable all
the way through, and push the tube into
the antenna holder on the remote control
(4B) or model (4C).
6 vEhiclE control
6A In order to drive forwards, push the button for forward and reverse travel (2A)
on the left side of the remote control forwards.
6B In order to drive backwards, push the lever for forward and reverse travel (2A)
backwards.
6C In order to drive along a left-hand curve, press the steering for right/left (2D)
on the remote control towards the left.
6D In order to drive along a right-hand curve, press the steering for right/left (2D)
on the remote control towards the right.
instructions For saFE driving
gEnERAl DRiVing TiPS:
• Always maintain visual contact with the vehicle and do not look at the remote
control!
• On initial driving attempts, there is a general tendency toward excessive movements
of the controls. Make sure that you have sufficient room.
After a crash, always release the button for forwards and reverse travel
immediately in order to prevent damage to the electronics.
THE SuiTABlE DRiVing EnViROnMEnT:
The location in which the vehicle is driven should fulfill the following criteria:
1. It should be a location in which there is as much open area as possible, without
disruptive obstacles.
2. Make absolutely sure when starting that there are no people or animals in the
immediate vicinity.
3. Always watch the vehicle so that it does not drive into the operator, other people
or animals and injuries them.
12
5 stEEring trim adjustmEnt
The correct trim is a basic requirement
for fault-free driving behaviour from the
vehicle. Adjusting the trim is easy, but it
requires a little patience and a feel for it.
Please follow the following instructions
precisely:
if the vehicle pulls to the left or the
right without being steered...
use the straight-ahead trimming (1E) to
correct the wheel alignment by turning it in
the opposite direction. The wheel alignment
can be found on the bottom of the vehicle
(cf. 5).

troublEshooting

Problem: The vehicle does not move.
Cause:
• The batteries are too weak and/or depleted.
Remedy: • The batteries were possibly not inserted correctly. Please observe the polarity
indication in the model
• Please replace with new batteries.
Problem: Remote control does not work.
Cause: • The batteries were not inserted correctly.
• The batteries do not have enough power.
Remedy: • Check whether the batteries are inserted correctly.
• Please replace with new batteries.
Problem: The vehicle cannot be controlled with the remote control.
Cause: • The batteries are depleted.
• The connection between the remote control and vehicle has been severed.
Remedy: • Insert new batteries.
• When the model is further than 10 metres away, move towards the model
Additional tips and trick can be found online at www.revell-control.de.
sErvicE notEs
go to www.revell-control.de for ordering information
and tips on replacing spare parts, plus other useful
information on all Revell Control models.
www.revell-control.de
13