Warranty - T.I.P. SPF 180 Gebrauchsanweisung

3. The pump stops after a short time
of operation because the thermal
motor protection feature has
triggered.
4. Low current
5. Noise in the pump during the
operation

10. Warranty

The present device was manufactured and inspected according to the latest methods. The seller warrants for faultless
material and workmanship in accordance with the legal regulations of the country in which the device was purchased. The
warranty period begins with the day of the purchase and is subject to the provisions below:
Within the period of warranty, all defects which are to be attributable to defective materials or manufacturing will be
eliminated free of charge. Any complaints are to be reported immediately upon their detection.
The warranty claim becomes void in the case of interventions undertaken by the purchaser or by third parties. Damage
resulting from improper handling or operation, incorrect setting-up or storage, inappropriate connection or installation or
Acts of God or other external influences are excluded from warranty.
Parts being subject to wear and tear are excluded from warranty.
All parts were manufactured using maximum care and high-quality materials and are designed for a long lifecycle. It
should be understood, however, that the wear and tear depends on the kind of use, the intensity of use and the internals of
maintenance. Complying with the installation and maintenance information contained in the present operating instructions
will therefore considerably contribute to a long lifecycle of these wearing parts.
In case of complaints, we reserve the option of repairing or replacing the defective parts or replace the entire device.
Replaced parts will pass into our property.
Claims for liquidated damages are excluded unless they are caused by wilful acts or negligence on the side of the
manufacturer.
The warranty does not provide for any claims beyond those referred to above. The warranty claim has to be evidenced by
the purchaser in the form of the submission of the sales receipt. The present warranty commitment is valid in the country
in which the device was purchased.
Please note:
1. Should your device fail to function properly, please verify first whether an operating error or another cause is present
which cannot be attributed to a defect of the device.
22
3. Check valve (non-return valve), if present,
is blocked or defective.
1. The electrical supply does not correspond
to the information given on the type plate
2. . Pump or intake openings are blocked by
solids.
3. Temperature of the liquid is too high.
4. Pump is running dry..
1. Dirty filter
2. Dirt in filter basket of sand filter
3. Blockage in the pipe
1. Defect bearing
2. Air penetrates into the intake line.
3. Blockade beim Ansaugen
4. Störung im Flügelrad
5. Störung beim Saugen
tight and not jammed;
d.) no siphons (i.e. permanently liquid-filled loops),
kinks, counter-slopes or narrow spots are present
along the intake lines.
3. Eliminate blocking of the check valve (non-return
valve) or replace, if damaged
Clean the insert of the pump and check any blockage
of the impeller
1. Please use a device complying with GS (German
technical supervisory authority) to check for the
presence of voltage (safety information to be
observed!).
2 Remove possible congestion.
3. Make sure that the temperature of the liquid being
pumped does not exceed the max. admissible value.
4. Eliminate causes of dry-running.
1. Rinse or clean the filter
2. Clean the filter basket of the tube
3. Check the pipes. Avoid any bending of hoses.
Flush with sufficient water in case of need.
1. Contact your local service partner or the
manufacturer
2. see section 2 of this table
3. Check and clean the suction hose
4. Contact your local service partner or the
manufacturer
5. Improve the suction inlet. Make sure the suction
inlet is under the water level oft he swimming pool.
Reduce the numbers of screws, assemble a pipe with
a larger diameter.
10