Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Starting locomotive operation
GB
Unwrap model:
Take out the model
cautiously with foil(fig. 1).
Operating instructions:
Before use is
advisable to let the loco go around about 30
minutes for-wards an 30 minutes
backwards without load, to obtain an
optomal circuit and best tractive power. The
smallest radius this model should run is
of the ROCO track system (R2 = 358 mm).
Your locomotive will run smoothly on clean
tracks only. For this purpose we
recommend using item no.
46400, Roco
track cleaning van,
or item no.
10002,
Roco track cleaning rubber,
for remo-ving
heavy dirt.
Fittings:
Operation is possible with
different cou-plings (fig. 2). We recommend
using the Roco close coupling.
4
In the enclosed accessory bag you will find
small kits to be fitted on your locomotive.
Please
mount them cautiously.
Attention!
Use glue only if indicated (fig. 2).
Running in digital mode:
Remove the jumper from the interface.
R2
Finally put the plug of the chip into the
interface as shown in fig. 5.
A.C. operation:
see fig. 10 + ( I - XII).
Maintenance of the model
GB
To enjoi your model for a long time, it is
service
necessary to
it regulary (i.e. after it
has been in ope-ration for approximately 30
hours).
1. Cleaning of wheel contacts:
Wheel
contacts easily get dirty on tracks which are
not entirely clean. Use a small brush to
remove dirt
from spots marked in fig. 6.
Prior to cleaning the con-tacts dismantle the
bogie (fig. 4).
2. Lubrication:
Apply
tiny oil drops
spots marked in fig. 7. Prior to lubrication
dismantle locomotive (fig. 3). We
recommend using item no.
10906, Roco
oiler.
For lubrication the gear-parts (e.g.
c o g - w h e e l s , w o r m ) w e w h o u l d
special grease
recommended our Roco
10905
(item no.
).
Attention:
Please do not oil these parts
when using our grease.
3. Change of traction tyre:
gear cover (fig. 4). Take out
wheel set
remove
traction tyre
using a pin or a fine
screwdriver (fig. 8). When pressing on the
new traction tyre please
avoid twisting it.
4. Carbon Brush Changing:
loco body (fig. 3), and then the motor (fig. 9).
Assembly
: During assembly please take
care of correct position of contacts.
to
Remove the
and
First remove
9
Werbung
