Electrical Connection - Franke CRYSTAL FH CR 604 4G Installationsanleitung

FH CR 301 1TC / 302 2G / 604 4G / 755 4G TC / 905 4G TC / 1204 3G TC
3
Refer to the information in chapter
X X
„Electrical connection" before
connecting the appliance.
Connect the appliance to the power
X X
supply.
4
Fit the appliance in the worktop
X X
correctly.
Apply the sealing strip around the
X X
hole and position the hob.
Fix the appliance with the screws and
X X
brackets.
Remove any excess sealing strip.
X X
5
If the appliance is not installed above an
oven:
Arrange a separator baffle.
X X
6
Minimum flame adjustment
Remove the knobs (push-on type).
X X
Light the burners.
X X
Adjust the minimum flame by turning
X X
the adjustment screw clockwise to
decrease the flame and anticlockwise
to increase it. The screwdriver for
adjustment is supplied with the
accessories.
Connection to gas supply
Connect the appliance to the gas
supply in compliance with the current
regulations, only after making sure it is
arranged for the type of gas to be used.
Otherwise, carry out the operations
described in the section on „replacing
injectors".
For liquid gas use pressure regulators
complying with the current regulations.
Connection to the gas supply can be
made in two ways:
A
Connect the gas hob using a 12 mm
X X
diameter rigid copper pipe (3). To
ensure a good seal, use the elastomer
gasket supplied as an accessory (1).
B
Connect the hob using a continuous-
X X
surface flexible steel tube (2).
Also in this case, to ensure a good
seal use the gasket supplied as an
accessory (1).
Make sure to comply with the current
regulations on gas systems.
After carrying out the connection use
X X
soapy water to check for any leaks.

Electrical connection

The FRANKE cooking hob comes with a
3-core power cable with free terminals.
Make sure the characteristics of the
X X
household electrical system (voltage,
maximum power and current)
are compatible with those of the
appliance.
If the appliance is to be permanently
connected to the power supply:
Install a device that enables
X X
disconnection from the power supply,
with a contact opening distance (3 mm)
that ensures complete disconnection in
category III overvoltage conditions.
– 7 –
EN