Installation; Identification Plate - Franke CRYSTAL FH CR 604 4G Installationsanleitung

FH CR 301 1TC / 302 2G / 604 4G / 755 4G TC / 905 4G TC / 1204 3G TC

INSTALLATION

Installation must be carried out in
compliance with current standards and
regulations.
Installation must be only be carried out
by specialized and licensed personnel.
The manufacturer declines any liability
for injury to persons or damage to things
due to failure non-compliance with
these provisions.
The gas connection must comply with
the regulations in force in the country
at the time of installation.

Identification plate

The identification plate is located
underneath the appliance.
Cabinet requirements
This handbook refers to a class 3 built-in
gas hob and type Y for electric part.
It is essential to make the opening in
the most convenient position, bearing in
mind that the gas pipe must not come
into contact with the sides of any oven
under the hob.
If fitting in flammable material, the
guidelines and standards for low voltage
installations and for the fire protection
must be strictly observed.
For fitted units, the components (plastic
materials and veneered wood) must be
assembled with heat-resistant adhesives
(min. 100°C): Unsuitable materials and
adhesives can result in warping and
detachment.
The kitchen element must allow
sufficient room for the electrical
connections of the appliance.
Suspended kitchen elements above
the appliance must be installed at a
distance that provided enough room for
comfortable working process.
Important: These devices are „Y" type
with respect to the degree of protection
against the dangers of fire. The use of
hard wood decorative borders around
the worktop behind the appliance is
allowed, providing a minimum distance
from the edge appliance of 50 mm for
the side wall, 50 mm for the rear and
700 mm for any cabinets above it.
The appliance is recommended to be
built into 50 mm thick worktops. In case
the dimensions are different, eventual
modifications have to be managed by
the technician.
– 5 –
EN