Center Of Gravity - Staufenbiel HYPERION Montageanleitung

19
20
The elevator just plugs sits on the carbon connector. There is no need to glue it. If it doesn't sit tight
enough, you should bend the steel connector a little bit until you have a tight fit.
The mark on the fuselage of the CG is at 90 mm behind the leading edge of the wing. The flight
characteristics are very docile using this CG. The CG can be moved back until around 105 mm in
order to gain higher performance of the model. The longitudinal dihedral should be set to a value
between 1,5° (CG 90 mm) and 1,0° (CG 100 mm). We wish you many happy landings with you
new Staufenbiel Hyperion.
Glue the small foam pieces with CA on the
servo cable. The foam will protect the cable
in the and avoid rattling noises. Guide the ser-
vocable through the wing.
Solder a Multiplex connector at the end of the
cable. Prepare the opposite part of the con-
nector too.
ASSEMBLY COMPLETION

CENTER OF GRAVITY

EN
19