INNOCIGS CUBOID BODY Bedienungsanleitung Seite 48

INNOCIGS CUBOID – OPERATING & CHANGING THE DISPLAY MODE
2. Installing new atomizer coils
If an atomizer coil is replaced with one which has a greater resistance than the previous one, it
is important to reset the "Base Resistance" of the atomizer. This is the resistance of the coil at
room temperature. Initiate a reset by pressing the fire button of the Cuboid while the clearomi-
zer and base are not attached. After connecting the clearomizers base with a new head, "New
Coil Right, Coil Same Left" will appear on the display. Confirm that a new coil has been installed
by pressing the "up" button.
If you see this message in other instances - especially when you reinstall the same coil which is still warm from
recent use - press the down button, so that the "base resistance" is not reset.
Always remember to adjust the operating mode of the coil used to ensure proper temperature control.
Since atomizer coils are wearing parts, they must be changed regularly.
47