Operation; Operating Instructions; Motor Start / Stopp; Notes - Zipper Maschinen ZI-FS115 Betriebsanleitung

13

OPERATION

13.1

Operating instructions:

 Put the tile cutter securely on the ground. The cutting blade must not be with the ground or
other objects in conjunction.
 Check each time before the blade is in good condition and securely attached
 Fill water into the tank of the device. The filling level is marked on the protective cover of the
cutting disc.
13.2 Operation:

13.2.1 Motor start / stopp

Switch ON
 Check that the blade runs freely.
 Ensure that the work surface is free of tools and objects.
 Turn on the machine by pressing one of the green ON button.
After switching on the device, wait until the device has reached its max. speed. Only then
must you start with the grinding.
Switch OFF
 Run the material from the blade.
 Turn on the machine by pressing from the red OFF button.
The disc will continue to run after the equipment is switched off. There is a risk of injury.

13.2.2 Notes:

 Cut only as fast as it allows the material. If the speed of the cutting wheel in the feed greatly
reduced, slow down the feed!
 No lateral pressure on the blade.
 No operation without mounted blade guard!
 Do not force material in the blade.
 No Dry cutting saw blades are suitable for wet cutting.
 No curves intersect.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-FS115
OPERATION
19