Assembly; Mounting And Changing The Diamond Saw Blade (B); Mounting The Saw Blade Cover (C); Mounting The Rip Fence - Zipper Maschinen ZI-FS115 Betriebsanleitung

12

ASSEMBLY

12.1

Mounting and changing the diamond saw blade (B)

 Unfold the work surface (A 4).
 Pull the folding work surface (A 4) out of the holder and place the holder to one side.
 Remove the protective cover of the cutting disc (18). In order to do this, pull the protective cover of
the cutting disc (18) towards the back and tilt it to one side. You can remove the protective cover of
the cutting disc (18) by pulling it upwards out of the water tank.
 Release the shaft nut (17).
 Remove the nut (17) and the pressure disc (16) from the shaft (13). The mounting flange (14)
remains on the shaft (13).
 Place the full-rim diamond cutting disc (15) on the shaft (13). Please note the direction of rotation.
This is marked on the full-rim diamond cutting disc (15) and on the protective cover (3).
 Push the pressure disc (16) with the straight side against the full-rim diamond cutting disc (15).
 Turn the shaft nut (17) using wrenches (1) and (2) to block the shaft (13). First attach wrench (1)
and then wrench (2).
 Attach the protective cover of the cutting disc (18) again. Insert the protective cover of the cutting
disc (18) into the floor guide of the water tank. Press the protective cover of the cutting disc (18) on
the left and push the protective cover back as far as it will go.
 Reinsert the folding work surface (A 4).
12.2

Mounting the saw blade cover (C)

 Remove the screw (23) from the device
 Place the angle bracket (22) in line behind the diamond cutting disc (15) through the mounting hole.
 Use the screw (23) to attach the retaining bracket (22) to the device.
 Align the angle bracket (22) with the diamond cutting disc (15).
 Push the protective cover (20) on to the retaining bracket (22).
 Screw the protective cover (20) on to the retaining bracket (22). For this, use the screw with the
star grip (21) and the nut (19).
The protective cover (3) cannot be rigidly fixed in place. It simply lies on top of the work surface.
12.3

Mounting the rip fence

 Insert the parallel stop (9) into the guide mechanism of the device at one end.
 Pull the guide clamp of the parallel stop (9) in order to be able to insert the guide mechanism on the
opposite side.
 Attach the two screws with a star grip to both ends of the parallel stop (9) in order to be able to
clamp the parallel stop into place.
 Clamp the parallel stop (9) firmly in place with the two screws with a star grip.
12.4

Checking the closure

 Unfold the work surface (4).
 Check that the closure (24) is firmly fixed in the drain hole (25).
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-FS115
ASSEMBLY
18