Yamaha NS-LC8 Bedienungsanleitung Seite 4

Notes:
• Do not place the speaker on top of the TV whose
area is smaller than the bottom area of the speaker.
If placed, the speaker may drop out causing an
injury to you.
• Do not place the speaker on top of the TV with an
inclination.
• Do not touch the adhesive surface after peeling off
the seal as this will weaken its adhesive strength.
• Thoroughly wipe clean the surface where the
fastener is to be applied. Note that adhesive strength
is weakened if the surface is dirty, oily or wet and
that this may cause the center speaker to drop.
■ Placing the surround speaker
NS-ELC8
• Attach the non-skid pads to the bottom of the
speaker, and then place the speaker on a level
hard surface.
• Using non-skid pads prevents the speaker from
sliding when it vibrates, and ensures quality
sound production.
4
E-
Note:
You can also use the screw holes on the bottom of the
NS-ELC8 for installing the speakers on commercially
available speaker stands.
• Before installing, please refer to the instruction
Removing the front cover
The front cover is attached to protect the speaker
unit, but you can remove it if necessary.
The front cover is fixed by magnets. Hold the
speaker with one hand, and pull the front cover
gently with the other to remove it.
Non-skid pad
Notes:
• When removing the cover, be careful that you don't
• There are magnets on the reverse side of the front
A screw with a
diameter of 6 mm can
be used (Hole depth:
10 - 13 mm)
manual of the speaker stand.
touch the drive units, and don't exert excessive
force with any tools.
cover. Do not place the front cover close to objects
that might be affected by magnets, such as TVs,
clocks, magnetic cards, diskettes etc. after
removing it.