Operation - Clatronic wk 2797 Bedienungsanleitung

5....-05-WK 2797
GB
1. Place the machine on a flat surface.
2. Please use the handle in the lid to open the kettle. Then fill in the water. Please
only fill up to the maximum (MAX) mark. You can read off the water level in the
water level display.
3. Close the lid until you hear it lock in place.
4. Place the kettle flush on the base.
5. Electrical connection
• Check whether the electrical voltage that you intend to use is the same as that
of the machine. Details are to be found on the label on the base.
• Only connect the machine to a properly installed 230 V, 50 Hz safety socket.
6. Switch the machine on with the switch on the handle.
7. The control lamp in the switch lights up.
8. When the water is boiling the kettle switches itself off automatically unless you
press the switch to interrupt or stop the water from boiling. Disconnect the kettle
from the mains. When pouring the water out, keep the lid closed. Danger of
scalding!
• Always pull out the plug from the socket before cleaning!
• The exterior of the machine should be cleaned, if necessary, with a slightly
damp cloth without additives.
• If you want to clean the inside of the kettle, please unhook the lid. This should
be cleaned either with a damp cloth or with detergent.
• When replacing the lid, note the markings on the kettle.
• There is a permanent filter in the spout. To clean this filter, press it towards the
inside with the lid open and then pull it out. Rinse out the filter with running
water.
• The frequency of the decalcifying operation depends on the hardness of the
water and on how often the appliance is used. Decalcify the appliance every 3
to 4 months.
• If the machine switches off before the water boils, it probably needs to be decal-
cified. Please do not use vinegar but a commercially available decalcification
agent on the basis of citric acid. Only use the quantities stated in the instruc-
tions.
22
13.03.2003 8:31 Uhr

Operation

Cleaning
Decalcification
Seite 22