Replacing The Cutting Head - UNITED OFFICE 69355 Bedienungshinweise Und Sicherheitshinweise

Replacing the cutting head

If the blade of the slitter rewinder has
been damaged, the cutting head must be
replaced.
1. Remove the end cap of the guide
rail from the base plate (Fig. 7, A) by
pushing it upwards at the lower end at
the same time as pushing it inwards
gently.
2. Turn the rotary knobs in such a way
that the LOCK lettering is at the top.
Pull out the rotary knobs approx. 1 – 2
mm from the device. Turn the knobs by
about 30 degrees and now pull them out
completely. Pull out the guide rail from
the base plate (Fig. 7, B).
3. Remove the cutting head from the guide
rail (Fig. 7, C).
4. Replace the old cutting head with a new
one.
5. Slide the guide rail back in the base
plate and install the new cutting head in
the process.
6. Turning them slightly, push the rotary
knobs into the device again (LOCK
lettering at the top, the noses pointing
inwards). Place the end cap from above
on to the opening at the end of the guide
rail.
Note: Only the entire cutting head can
be replaced. To obtain a new cutting
head, please telephone our hotline.
Guarantee
It is essential to retain this guarantee!
Dear Customers,
we are pleased that you have chosen the
reversible guillotine / trimmer. Should a
technical problem arise with regard to the
equipment, please observe the following
points:
- The period of guarantee for the equipment
is 36 months.
- It is essential to keep the purchase receipt
and original packing.
- The first line of action if a problem occurs
8 GB/IE
69355_uof_2in1_papierschneidegeraet_content_lb3.indd 8
is to contact our hotline.
Hotline international
00800 100 22 100
We are sorry for any inconvenience.
Yours faithfully
Olympia Business Systems
Vertriebs GmbH
Consumables
If the cutting head or blade becomes worn,
please contact the hotline. You will receive
a new cutting head from us together with
detailed illustrated instructions.
26.07.2011 14:40:24