Beko WMB 81442 LAM Handbuch Seite 69

You can remove the filter cover by slightly pushing
C
downwards with a thin plastic tipped tool,
through the gap above the filter cover. Do not use
metal tipped tools to remove the cover.
Some of our products have emergency draining hose
and some does not have. Follow the steps below to
discharge the water.
Discharging the water when the product has an
emergency draining hose:
Pull the emergency draining hose out from its seat
Place a large container at the end of the hose. Drain
the water into the container by pulling out the plug at
the end of the hose. When the container is full, block
the inlet of the hose by replacing the plug. After the
container is emptied, repeat the above procedure
to drain the water in the machine completely. When
draining of water is finished, close the end by the plug
again and fix the hose in its place. Turn the pump filter
to take it out.
Discharging the water when the product does not
have an emergency draining hose:
Place a large container in front of the filter to catch
water from the filter. Loosen pump filter (anticlockwise)
until water starts to flow. Fill the flowing water into the
container you have placed in front of the filter. Always
keep a piece of cloth handy to absorb any spilled
water. When the water inside the machine is finished,
take out the filter completely by turning it. Clean any
residues inside the filter as well as fibers, if any, around
the pump impeller region. Install the filter.
If your product has a water jet feature, be sure
A
to fit the filter into its housing in the pump. Never
force the filter while installing it into its housing.
Seat the filter into its place completely. Otherwise,
water may leak from the filter cap.
If the filter cap is composed of two pieces, close the
filter cap by pressing on the tab. If it is one piece, seat
the tabs in the lower part into their places first, and
then press the upper part to close.
69
EN