Adjusting The Feet; First Use; Electrical Connection; Disposing Of Packaging Material - Beko WMB 81442 LAM Handbuch

• To prevent flowing of dirty water back into the
machine and to allow for easy discharge, do not
immerse the hose end into the dirty water or drive
it in the drain more than 15 cm. If it is too long,
cut it short.
• The end of the hose should not be bent, it should
not be stepped on and the hose must not be
pinched between the drain and the machine.
• If the length of the hose is too short, use it by
adding an original extension hose. Length of the
hose may not be longer than 3.2 m. To avoid
water leak failures, the connection between the
extension hose and the drain hose of the product
must be fitted well with an appropriate clamp as
not to come off and leak.

Adjusting the feet

In order to ensure that the product operates more
A
silent and vibration-free, it must stand level and
balanced on its feet. Balance the machine by
adjusting the feet. Otherwise, the product may
move from its place and cause crushing and
vibration problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands level and
balanced.
3. Tighten all lock nuts again by hand.
Do not use any tools to loosen the lock nuts.
A
Otherwise, they will get damaged.

Electrical connection

Connect the product to a grounded outlet protected
by a fuse complying with the values in the "Technical
specifications" table. Our company shall not be liable
for any damages that will arise when the product is
used without grounding in accordance with the local
regulations.
• Connection must comply with national
regulations.
• Power cable plug must be within easy reach after
installation.
• The voltage and allowed fuse or breaker
protection are specified in the "Technical
specifications" section. If the current value of
the fuse or breaker in the house is less than 16
Amps, have a qualified electrician install a 16
Amp fuse.
• The specified voltage must be equal to your
mains voltage.
• Do not make connections via extension cables or
multi-plugs.
Damaged power cables must be replaced by the
B
Authorized Service Agents.

First use

Before starting to use the product, make sure that
all preparations are made in accordance with the
instructions in sections "Important safety instructions"
and "Installation".
To prepare the product for washing laundry, perform
first operation in Drum Cleaning programme. If
your machine is not featured with Drum Cleaning
programme, use Cottons-90 programme and select
Additional Water or Extra Rinse auxiliary functions as
well. Before starting the programme, put max. 100 g
of powder anti-limescale into the main wash detergent
compartment (compartment nr. II). If the anti-limescale
is in tablet form, put only one tablet into compartment
nr. II. Dry the inside of the bellow with a clean piece of
cloth after the programme has come to an end.
Use an anti-limescale suitable for the washing
C
machines.
Some water might have remained in the product
C
due to the quality control processes in the
production. It is not harmful for the product.

Disposing of packaging material

Packaging materials are dangerous to children. Keep
packaging materials in a safe place away from reach
of the children.
Packaging materials of the product are manufactured
from recyclable materials. Dispose of them properly
and sort in accordance with recycled waste
instructions. Do not dispose of them with normal
domestic waste.

Transportation of the product

Unplug the product before transporting it. Remove
water drain and water supply connections. Drain
the remaining water in the product completely; see,
"Draining remaining water and cleaning the pump
filter". Install transportation safety bolts in the reverse
order of removal procedure; see, "Removing the
transportation locks".
58
EN