Measuring Procedure - ULTIMATE SPEED ULSP 2 A1 Bedienungsanleitung

Measuring procedure

GB
Normal measuring mode
CAUTION
► Place the device carefully on the surface to be meas-
ured, and do not move it during measuring. Remove
the device carefully from the surface after measuring,
otherwise you could cause scratches on the paintwork.
♦ Remove the protective cap
(standby mode).
♦ Keep the device away from any surfaces and then press
the TEST button
nently and the device is now in normal measuring mode.
♦ Place the measuring sensor
surface to be measured. The measured paint thickness
will be signalised by one of the three LEDs
(see table).
LED colour
Red
Yellow
Green
♦ Press the TEST button
The red LED fl ashes.
6
and switch the device on
. The red LED will illuminate perma-
at right angles to the
Paint thickness
> approx. 1.8 mm
approx. 1.0–1.8 mm
< approx. 1.0 mm
again to return to standby mode.
illuminating
ULSP 2 A1